 |
|
 |
 |
|
|
|
|
|
 Latest News |
| |
| April 23, 2010 - June 19 - 24, 2010: Orochem Technologies will be attending HPLC 2010 to be held in Boston. | | | | April 23, 2010 - May 24 - 26, 2010: Orochem Technologies will be attending ASM 2010 to be held in San Diego. | | | | April 23, 2010 - May 9 - 11, 2010: Orochem Technologies will be attending PREP 2010 to be held in Philadelphia. | | |
|
| |
More News... |
|
Technical Corner |
| |
Catalog
|
| |
Application Notes
|
| |
Handbooks & Protocols
|
| |
Newsletters
|
|
Special Offers |
| |
Register online and avail up to 20% off of on all HPLC columns. Contact us today at 630.916.0225 for details
|
|
|
|
| |
| |
- Fine needle valve flow control of nitrogen
- Luers at any position can be plugged to as many or as few as needed
- Nickle plated Aluminium for solvent resistance
- Can be heated by placing on lab hotplate
|
- Dual fine needle valve control of nitrogen
- Any position can be plugged to use as many positions as needed
- Nickle plated Aluminium for solvent resistance
- Can be heated by placing on lab hotplate
|
| |
|
|
| Each Evaporator includes a base stand, needle valve, 6 or 12 threaded male needle luer locks, 6 or 12 lure hub stainless steel needles with blunt points, and 6 or 12 plastic end caps. The needle valve allows a fine control of the air stream or gas flow. |
| |
- Gas flow should be fast enough to evaporate, but not so fast as to splatter the liquid being evaporated
- For fewer vials, remove the needles from the needle locks that are not being used and plug with the plastic stoppers provided. To insure against contamination, plug up the male luer locks farthest from the needle valve first
- If a vial is too tall, some bending of the needle can be done to fit the container. Take care not to crimp the needles.
- To adjust the horizontal position, rotate the needles in the luer hubs by twisting them to the desired position
|
| |
|
|
|
|
|
| |
|
|
|
|